Page 108

Warwick Electrical Product Guide

T a C 360° Flush Mount Ceiling PIR 7 Day Digital Security Light Switch Infra-Red Light Switch with Presence Detector (with Optional Dusk Start) Remote Control • Flush mounting. • 360° ceiling flush mount PIR presence detector. • 6m diameter (3m radius) detection range at 2.5m mounting height • No creep zone - maximum coverage. 24 hour/7 day digital light switch which will automatically • Light ON time adjustable from 5 seconds to 18 minutes. turn filament, fluorescent, low energy and low voltage • Manual ON/OFF override. lights ON & OFF at pre-programmed times. An optional An attractive infra-red light switch with remote • IP44 weatherproof rating (also suitable for outdoor use). dusk start feature turns lights ON at dusk and OFF at a control for quick and easy dimming and ON/OFF • Adjustable light level control. programmed time. control of room lights up to 300W. The light(s) under • Total PIR switching: 2000W (e.g. 20x 100W GLS) control can either be switched ON/OFF or dimmed incandescent or halogen, 500W fluorescent/low energy. • 6 ON/OFF switching programmes. by the hand held remote control or by the push • Not suitable for discharge lighting. • Can be set to operate over all weekdays, both weekend button on the switch. • 75W fan. days, all 7 days (24 hour operation) or on individual days. Product Code Description • Three position slide switch allows manual operation, • Remote ON/OFF control and dimming control of light(s)for convenience and ease of operation.auto operation with timed ON's and OFF's or auto and TISLFM360 360° Flush Mount Ceiling PIR Presence • Optional light switch or remote operation.photocell operation giving dusk start and timed OFF Detector • Remote control with range up to 8 metres ±50°.with additional timed ON's and OFF's if required. • Built-in 1000 hour rechargeable battery retains • Maximum of 4 light switches can be controlled by programmes and clock times during power failure. channel selection on remote control. • Controls 40 - 300W of filament, 20 - 150W low energy • Controls up to 300W of filament lighting (including Programmable Security Light Switch (minimum bulb size 20W), 18 - 76W of fluorescent and halogen). Not suitable for fluorescent, low energy or 20 - 200W of low voltage lighting. low voltage lighting. • Note: FLA01 strip light adaptor may be required in • Replaces any conventional single gang ON/ OFF light certain installations. switch (not 2 way). Product Code Description Product Code Description TIZV700 7 Day Digital Security Light Switch (with TIRLSO10 Infra-Red Light Switch with Remote Optional Dusk Start) Control Motion Sensor PIR Light Switch Programmable Security Light Switch will turn a light ON Detects PIR body heat motion and automatically switches automatically when it gets dark and can be programmed the light ON, turning it OFF again after a time adjustable to turn OFF again up to approximately 8 hours later. Easy from 6 seconds to 12 minutes. to install and operate, a direct replacement for an existing wall switch and can also be used as a normal ON/OFF • AUTO/ON/OFF selections. switch. • 180° detection area with adjustable 8m detection range. • Light ON times adjustable from 6 seconds to 12 minutes. • Light ON time programmable for up to 8 hours • Fully adjustable light level control. approximately. • Can also be used as a normal ON/OFF or 2 way switch. • Adjustable light level control for dusk switching to • Suitable for lamp loads: 40 - 500W incandescent, compensate for differing light levels within a building. 40 - 150W low voltage halogen, 18-150W fluorescent • Note: FLA01 strip light adaptor will allow operation with with electronic bal last, 15-150W electronic PL lamp up to 85W of fluorescent or low energy lamps. (Philips or Osram only). Product Code Description Product Code Description TIZV210 Programmable Security Light Switch TIZV810 Motion Sensor PIR Light Switch 106 !!!.!!.. #  !!.. 


Warwick Electrical Product Guide
To see the actual publication please follow the link above